| |
Repsol Ibertem 15
Translation of the original Spanish. In case of a discrepancy, the Spanish original prevails
Description and Recommendations
A natural paraffin mineral oil with low viscosity, formulated with refined base oils and specially selected additives, which provide the properties required to overcome the difficult conditions needed for the normal hot dip coating of steel. Ibertem-15 is particularly suitable for normal, cold hardening work; where the bath temperature is between 40 and 80oC. This kind of oil is used with steel alloys and is formulated to last a long time.
Properties
Appropriate additives are used to achieve good resistance to oxidation and the formation of sludge and dirt.Vey good thermal stability and low volatility, which reduces smoke and the risk of fire.Good foam resistance.Uniform and lasting hardening capacity.
Technical characteristics
|
UNITS |
METHOD |
VALUE |
Appearance |
|
|
Glossy and transparent |
Colour |
|
ASTM D 1500 |
< 2,5 |
Density at 15oC |
g/ml |
ASTM D 4052 |
0,865 |
Viscosity at 40oC |
cSt |
ASTM D 445 |
24 |
Viscosity at 100oC |
cSt |
ASTM D 445 |
4,5 |
Viscosity rate |
|
ASTM D 2270 |
100 |
Flammability V/A |
oC |
ASTM D 92 |
220 |
Aniline point |
oC |
ASTM D 611 |
95 |
Neutralisation index |
mg KOH/g |
ASTM D- 974 |
0,1 |
Noack volatility, 1hr at 150oC |
|
DIN 51581 |
0,85 |
Copper corrosion |
|
ASTM D 130 |
1b |
Overview
Bulk, 830kg containers and 185kg cans.
Hazard identification
This product is not classified as toxic or hazardous under current legislation.
Handling
Minimum precautions should be taken to avoid prolonged contact with the skin. The use of gloves, visors or glasses is recommended to avoid splashes.
Health and safety risks.
Inhalation: As this product has low volatility, the risk of inhalation is minimal.Ingestion: Do not make an affected person vomit. Supply water. Get medical help. Contact with the skin: Wash thoroughly with soap and water.Eyes: Wash thoroughly with water.General measures: Get medical help.
Fire-fighting measures
No special measures required.Extinction: Foams, dry chemicals, CO2, water spray. Do not apply a jet of water directly, as it could spread the product.
Environmental precautions
Danger of physical pollution if spilt (water, coastlines, soil, etc.) due to its floatability and oily consistency that may harm flora and fauna on contact. Prevent the material from entering the water supply. Decontamination and cleaning: Treat as an accidental oil spillage. Avoid dispersion using
mechanical barriers and remove with physical or chemical elements. |
|
